Hello Vindö lovers,
Could anybody help me with a wiring diagram with legend for a vindö 50.
It would help a lot to sort things out.
Kind regards,
Wim
vindö 50 schaltplan
Moderatoren: vindoede, Moderatoren
-
- Schiffsjunge
- Beiträge: 2
- Registriert: Donnerstag 3. Dezember 2020, 11:55
Re: vindö 50 schaltplan
Good day Wim, unfortunately there are no wiring diagramms for our boats. So you must follow them through the boat till the end. But there are not so much, so you will have success. Probably you will recognize, that it will be the best to renew most of them and to choose new better cable ways. At the end you may dicide to install a new switchboard ready for new technic. So I did it over the years.
Good luck
Mats
V 50 Ketsch
Good luck
Mats
V 50 Ketsch
-
- Schiffsjunge
- Beiträge: 2
- Registriert: Donnerstag 3. Dezember 2020, 11:55
Re: vindö 50 schaltplan
Thank you Mats for the reply. I had hoped that some consistency was used in the numbering.
What Vindö originally installed was not so bad for its time.
It is what previous owners added/changed in those 40 years that made it a bit a mess.
Kind regards,
Wim
What Vindö originally installed was not so bad for its time.
It is what previous owners added/changed in those 40 years that made it a bit a mess.
Kind regards,
Wim
- Saltkrokan
- Ruderer
- Beiträge: 19
- Registriert: Dienstag 17. November 2020, 07:48
- Wohnort: 69493 Hirschberg
Re: vindö 50 schaltplan
Hello Wim,
I am late with my answer. But perhaps this can help.
I found this two plans on my Vindö 50.
The connections to the devices are now completely changed, but the the way from the battery to the switch panel and the measure instruments stayed in place.
I for myself will remove everything and rebuild the whole system new. Then I know where everything is.
I will have new cables in the correct thickness and leading through cable canals.
Kind regards
Andreas
I am late with my answer. But perhaps this can help.
I found this two plans on my Vindö 50.
The connections to the devices are now completely changed, but the the way from the battery to the switch panel and the measure instruments stayed in place.
I for myself will remove everything and rebuild the whole system new. Then I know where everything is.
I will have new cables in the correct thickness and leading through cable canals.
Kind regards
Andreas
Seglerische Grüsse
Andreas
Vindö 50 SL Baunr. S1159, Segelnr. 202(?) Saltkrokan ex Pramod
Andreas
Vindö 50 SL Baunr. S1159, Segelnr. 202(?) Saltkrokan ex Pramod